BSOD Error || Stop 0x0000002E or DATA_BUS_ERROR

BSOD Error || Stop 0x0000002E or DATA_BUS_ERROR

How to Fix BSOD Error code 0x0000002E

Tech Advise:1

 Please do the steps to  fix BSOD Error || Stop 0x0000002E or DATA_BUS_ERROR
 Please verify that the RAM is the correct type for this installation & is correctly rated for speed voltage & other parameters required by your specific computer.
 If everything is correct contact the manufacturer of your computer’s motherboard for BIOS updates.

Tech Advise:2

 If your computer manufacturer provided a hardware test utility use it to diagnose which RAM module is bad.
 If you don’t have a diagnostic application remove all but one RAM module and reboot your computer.

Tech Advise 3

 Run Check Disk Command
 Fix Errors & Speed up through Chkdsk Command
 Repair Hard Drive through check disk Command
 Reboot Your PC, press F8 key continously while the PC is rebooting until a black window appears. Select command prompt from the list. Now on the Dos window Type chkdsk c: /f /r nter
 (you may get a prompt to press Y/N) Press Y which means that check disk command will run on net boot UP. Please allow the commad to run on next boot UP and do not exit. This may take 30 min – 1hour.

NOTE: the /f command automatically fixes any errors encountered, the /r command locates bad sectors and recovers readable information This will definately help to fix any drive related errors and speed up Your PC performance

Cause Of Error BSOD Error || Stop 0x0000002E or DATA_BUS_ERROR

 The Cause of the problem can be due to the following reasons
 The cause is typically failed or defective RAM  including motherboard  Level 2 cache  or video memory  incompatible or mismatched memory hardware Or when a device driver attempts to access an address in
 The 0x8xxxxxxx range that does not exist  does not map to a physical address
 A Stop 0x2E message can also indicate hard disk damage caused by viruses or other problems

Fix BSOD Error code 0x0000002E

fix Blue screen 0x0000002E Fix “STOP: 0x0000002E” Errors DATA BUS ERROR BSOD 0x0000002E in Windows 10 Bug Check 0x2E DATA_BUS_ERROR “DATA_BUS_ERROR ” (0x0000002E) BSOD Error

Leave a Reply

Scroll to top